OLGA Tutorial: Natural flow well model using OLGA

[FANARCO]

Great step by step tutorial: How to model natural flow well using SPT Schlumberger OLGA (Real data will be used for this tutorial)..

Well Name: A10

Offshore

High GOR


will use OLGA 2014 in our study but any version of OLGA is OK.

Follow us...

[FANARCO]

Open OLGA

New

Point to Empty project and name the project with whatever you want.

In our case the project name is "A10"

Save

[FANARCO]

Attached is the wellbore (completion) sketch diagram to be used for our well model

[FANARCO]

Under Categories cases choose Well Dry tree by double clicking on its pic, the following screen will appear

[FANARCO]

Click on OLGA well Editor icon on the top


The following screen will appear

[FANARCO]

Put the required info as displayed and go to next tab : "Profile"

[FANARCO]

Copy the deviation survey data in the attached sheet and right click on the top left corner of the grid, paste.

You should have the deviation data loaded with the well path as displayed

below...

[FANARCO]

Click "Casing" tab and enter the casing information as per included in post #3 wellbore (completion) sketch diagram

[FANARCO]

Now go for Tubing tab next to Casing and enter the tubing (completion) information as per completion sketch in post # 3

Choose "Single tubing"

[zamc]

Morning Guy,

I followed this tutorial but Im stick just here. Would you expect to continue this ? I though it was the easiest tuto on Olga I've never seen. Please we're waiting.

[FANARCO]

Morning Guy,

I followed this tutorial but Im stick just here. Would you expect to continue this ? I though it was the easiest tuto on Olga I've never seen. Please we're waiting.

Great,,

Since we found no contribution from the members.

Most of them read only we stopped.

If you completed these steps please attache your file to continue working on it...

[zamc]

....And the step im stucking on. I think the community would apreciate this great tutorial. Cuz off the lack on training practical materials on Olga software.

Regards.

[zamc]

Humm... My bad, I forgot the opi file. Please find it attached here.

Regards.

[FANARCO]

Humm... My bad, I forgot the opi file. Please find it attached here.

Regards.

where is it

nothing attached

[fel10]

Hi guys! I do not know where to find information of the eighth post, I know in the calculation table of the third post, but do not know exactly how much these data are internal diameter. Thank you. Incidentally, the best tutorial I've seen of OLGA.