ESP pumps for 5 1/2 in casing
Moderator: Production
ESP pumps for 5 1/2 in casing
Can anyone tell me, from his experience, what type of ESP pump for higher rates...about 300 - 500 cm/day is proper to install in a well with 5 1/2 in casing and 800 meters, without problems to extract back the pump ?
you must design your ESP based on your reservoir, i can't answer your question based on rate, all type pump (ESP) can handle big rate (>100,000 bbl/D)
because your design pump basd on type your reservoir fluid, cable size and also the dept.
so make good preparation for design ESP.
I can help you how to design if you needed.
God Bless you,
Regards,
D
because your design pump basd on type your reservoir fluid, cable size and also the dept.
so make good preparation for design ESP.
I can help you how to design if you needed.
God Bless you,
Regards,
D
I recommend to use jet pump in your case :
- No need for the rig to install. Just slick line to set it in SSD
- No electric source needed
- Very cheap tool, you can rent it for 100 $/day
- The power fluid is easy to get free as a sea water
- Require only a separator and surface high pressure pump,
- If you want i can design and select the proper pump size/ performance. Just send me the wellbore schematic and reservoir data
- No need for the rig to install. Just slick line to set it in SSD
- No electric source needed
- Very cheap tool, you can rent it for 100 $/day
- The power fluid is easy to get free as a sea water
- Require only a separator and surface high pressure pump,
- If you want i can design and select the proper pump size/ performance. Just send me the wellbore schematic and reservoir data