Need help about Error
Moderator: Simulation_team
Need help about Error
I'm very new with Eclipse and I got many error messages from running the model in E100 until the maximum limits have been reached. It's mainly about non-linear equation convergence failure.
Anyone know about this error and how can I correct them?
Thanks in advance
Anyone know about this error and how can I correct them?
Thanks in advance
- Bilal Amjad
- Senior member
- Posts: 258
- Joined: Sat Sep 20, 2008 12:14 am
- Location: اسلامی جمہوریہ پاکستان
Add Components in E300
Thank you Bila for you suggestion, I'll check it
Another question is that I'm trying to add component into E300 in PVT section and then Miscellaneous. However, as I put NCOMPS (number of components) equals to 11, it will show only one component in the CNAMES (name of components).
So that I don't know how to put it
Another question is that I'm trying to add component into E300 in PVT section and then Miscellaneous. However, as I put NCOMPS (number of components) equals to 11, it will show only one component in the CNAMES (name of components).
So that I don't know how to put it
- Bilal Amjad
- Senior member
- Posts: 258
- Joined: Sat Sep 20, 2008 12:14 am
- Location: اسلامی جمہوریہ پاکستان
- Bilal Amjad
- Senior member
- Posts: 258
- Joined: Sat Sep 20, 2008 12:14 am
- Location: اسلامی جمہوریہ پاکستان
The problem seems to me rather software related like bug or else.
Try any of below
1- First enter NCOMPS 11 and then enter CNAMES, if you see 1 field under CNAMES close the window after saving the changes. Reopen and now check CNAMES
2- Also use COMPS in RUNSPEC Section / Data Manager
Try any of below
1- First enter NCOMPS 11 and then enter CNAMES, if you see 1 field under CNAMES close the window after saving the changes. Reopen and now check CNAMES
2- Also use COMPS in RUNSPEC Section / Data Manager
Bilal Amjad
Reservoir Engineering Consultant
Reservoir Engineering Consultant