Need help with Eclipse simulation

Ivanski · Post by **Ivanski** » Fri May 18, 2012 7:37 pm

Hi,

I need a help with making a reservoir simulation program. Everything is looks fine beside AQUCON. I am not sure what numbers shell i use. Can someone help me out?
I can upload a text of the exercise and my answer as well.

Aquifer
The part of the west- and south side of the reservoir that initially is below water (deeper than the oil water contact) is connected to an aquifer. The contact surface (X-section) between the aquifer and the reservoir is 464400 m2. (Aquifer to reservoir tran-mult is 1.0.) How far the aquifer reaches (

Bilal Amjad · Post by **Bilal Amjad** » Sun Aug 05, 2012 1:24 am

Have seen the AQUCON keyword in the ECLIPSE manual?

gridsick85 · Post by **gridsick85** » Thu Jan 09, 2014 2:33 pm

this is as example of AQUCON:

--NUM I1 I2 J1 j2 K1 K2 FACE
1 12 24 102 113 1 1 'j+' /
1 12 24 102 113 2 2 'j+' /
1 12 24 102 113 3 3 'j+' /
/

Regards

Post by **FANARCO** » Thu Jan 09, 2014 10:57 pm

We can use aquifer in PETREL to be in direct contact with the reservoir directly under OWC and the software will consider it in communication.