Importing Eclipse data file to Petrel

[Tejaswy]

Hi guys,

I always had troubles importing Data file of Eclipse into Petrel.
Can you help me out here.

Posted below are some screenshots of how I do it.

There is an inherent flaw to importing data files into Petrel.
The heights of the reservoir are normally given in "-" in Petrel where as in Eclipse they are given in "+"

Move over I simple have troubles in simulating the imported data file in Petrel. I have to go defining the simulation case all over again in Petrel and it ends up giving me errors.

Can you help me out please.
Given below a series of screen shots.


Regards
Tejaswy

[FANARCO]

Dear TJ;

Alot of steps that you should follow to import the ECLIPSE data into Petrel:

1- Copy your eclipse file/s in a new folder (In our case we will copy SPE1_ODEHIMPES.DATA in a folder called SPE01)

2- Open Eclipse Simulation Launcher and click on Add Dataset as per Image

[FANARCO]

[align=center]3- Point to the data file and click open as per image

[/align]

[FANARCO]

4 - Click Run.... this will run the simulation dataset

[FANARCO]

5- Close the simulation launcher and open petrel

[FANARCO]

[align=center]6 - Go to Cases Tab and right click Import (On tree) as per image[/align]

[FANARCO]

7- A new window will opened. point to the eclipse folder you created and choose ALL files inside it and click OPEN

[FANARCO]

8- A new window will appear automatically click OK

[FANARCO]

9- In the following message click Continue

[FANARCO]

10- Now the data is loaded into Petrel and you can check the wells section and models, results tab


[align=center][/align]

[Tejaswy]

I still have troubles simulating my reservoir even if i import the data file the way you said.


For people who have the older version of Eclipse ( with out the simulation launcher).

Make the data file
Simulate the data file
Then you follow from the PDF i have attached in my first post.

[FANARCO]

Ok sir, please share your data file here as a zip file so we can investigate further