ECLIPSE observed vs simulated values
Moderator: Simulation_team
ECLIPSE observed vs simulated values
Hello;
Is it possible to compare directly (SBHP ,PI , KH and FBHP) of build-up test for a well to simulated values from ECLIPSE(WBP WPI KH WBHP)?
Is it possible to compare directly (SBHP ,PI , KH and FBHP) of build-up test for a well to simulated values from ECLIPSE(WBP WPI KH WBHP)?
Normally what I would do is compare SBHP to WBP9, which is the average pressure taken over the 8 blocks surrounding the well and the cell in which the well is in.
I'm not sure if you can compare kh from well test directly with kh from simulator. kh is estimated from well test based on the assumption that only single fluid is flowing, while you may have two phases actually flowing. That will affect your calculated kh, which may not turn out to be the absolute kh as calculated by the simulator.
I may be wrong...
I'm not sure if you can compare kh from well test directly with kh from simulator. kh is estimated from well test based on the assumption that only single fluid is flowing, while you may have two phases actually flowing. That will affect your calculated kh, which may not turn out to be the absolute kh as calculated by the simulator.
I may be wrong...