Question : ESP Design affected by Gas

KUH · Post by **KUH** » Fri May 09, 2008 9:37 pm

Dear Fanarco Members,
Please help me : how to design ESP if any high GOR in surface.

Thanks...

Post by **FANARCO** » Sat May 10, 2008 6:20 pm

I think more that 4000 SCF/STB GOR it is not allowed to use ESP
Try another artificial lift like gas lift or Jet pump...... etc depends on your conditions

KUH · Post by **KUH** » Sun May 11, 2008 11:27 am

In our field GOR still between 100 - 400 scf/stb.

I change my question : how to calculate Intake Pressure/ Pwf/ Ps if any GOR in surface. Available data : BFPD, BOPD, WFL (working fluid level) and SFL (Static Fluid level), SG oil, water & gas.
IF No GOR, I was used to apply below formulas :
SG Composite = SG water * WC + SG oil * (1-WC)
Intake Pressure = (Pump Setting Depth - WFL) * 0.433 * SG Composite
etc.

ETMANCO · Post by **ETMANCO** » Wed Jun 04, 2008 8:49 pm

Dear Member;
there are Four basic metods used to avoid or control high GOR
1-Gas Separation
2-Gas Handling
3-Gas avoidance
4-VSD

so please find the attached file which shows all you need

Eng.Abdel Fattah

a7madstyle · Post by **a7madstyle** » Fri Jun 06, 2008 7:56 pm

Dear ETMANCO

Could u download this pdf file on 4shared or fanarco upload center please !

zlith · Post by **zlith** » Tue Jun 17, 2008 8:41 pm

thanks for sharing!!!

.::FANARCO::.

Question : ESP Design affected by Gas

Question : ESP Design affected by Gas

Best reply