Need help about Error

parkoto · Post by **parkoto** » Sat Dec 22, 2012 9:57 pm

I'm very new with Eclipse and I got many error messages from running the model in E100 until the maximum limits have been reached. It's mainly about non-linear equation convergence failure.

Anyone know about this error and how can I correct them?

Thanks in advance

Bilal Amjad · Post by **Bilal Amjad** » Sun Dec 23, 2012 4:42 pm

Check your relative perm, capillary pressure curves. Are they smooth or experience rapid change with saturation?

parkoto · Post by **parkoto** » Mon Dec 24, 2012 3:13 pm

Thank you Bila for you suggestion, I'll check it

Another question is that I'm trying to add component into E300 in PVT section and then Miscellaneous. However, as I put NCOMPS (number of components) equals to 11, it will show only one component in the CNAMES (name of components).

So that I don't know how to put it

Bilal Amjad · Post by **Bilal Amjad** » Mon Dec 24, 2012 3:35 pm

What I get, your application is having some working problem. Can you post the snap shots of the PVT workflow.
thanks.

parkoto · Post by **parkoto** » Mon Dec 24, 2012 6:11 pm

Here's the screen capture from my software.

Bilal Amjad · Post by **Bilal Amjad** » Wed Dec 26, 2012 11:55 am

The problem seems to me rather software related like bug or else.
Try any of below

1- First enter NCOMPS 11 and then enter CNAMES, if you see 1 field under CNAMES close the window after saving the changes. Reopen and now check CNAMES

2- Also use COMPS in RUNSPEC Section / Data Manager

.::FANARCO::.

Need help about Error

Need help about Error

Add Components in E300